WAVE RIDER II (3-15 KW)

FEATURES

CSA Listed to UL 924, UL1778

3 and 5 kW in one cabinet

10, 12.5, & 15 kW one inverter and only one battery cabinet

Battery management system

Battery exerciser

True no break power to the load

LCD panel for monitoring of continuous self diagnostic

Seismic rated with bracket kit.

RS 232 & RS 485

90% Efficiency

Pulse width modulated (PWM) generator compatible

Sinusoidal wave

Incandescent, Fluorescent, HID, HPS

Power factor & energy efficient ballast.

Global Monitoring System Option

SPECIFICATIONS

Power Rating: 3, 5, 7.5, 10, 12.5, and 15 KW
Input Voltage: 3 & 5KW ....120, 208, 240, or 277 VAC (-20% to +15%) 7.5, 10, 12.5, & 15kW ...... 208, 240 or 277VAC (-15% to +15%)
Output Voltage: 120 Volt Only, or 277 Volt with external Isolation Transformer Only
Output Frequency: (Inverter Operation): 60Hz +0.5Hz.
Output Voltage Reg.: +3% Regulated within CBEMA curve
Output Wave Form: Sine-wave
Input Protection: Input circuit breaker provided protection to the unit, load and personnel. Input Circuit Breaker will be higher interruption rated 42 (KAIC) breaker as standard.
Output Protection: Internal Electronic overload protection. Circuit breaker provides inherent over-load protection. Factory selectable voltage 120, 208, 240, or 277 for input or output voltages. If input is different from output or output different from input, an internally mounted transformer is required.
Serge Protection: The inverter will protect itself and the load against surge as defined in ANSI/IEEE C62.45 category A and B.
Power Factor: 1.0
Isolation: Output is completely isolated from input, and with multi voltages, when input & output is different.
Noise Isolation: -120 dB. Common-Mode. 60 dB. Transverse-Mode
Efficiency: 90% minimum
Crest Factor: 3.1 Typical (may vary by model)
Battery: Sealed maintenance free
Battery Mngmnt System: Utilizes a microprocessor technology to monitor the batteries critical levels and apply charging cycles in a method to substantially increase battery life.
Housing: Free standing NEMA 1 Enclosure Power coated paint Front access only Multiple conduit entries Refer to chart for dimensions
Recharge Time: Approx. 16 times discharge rate
Environmental: Humidity: 0-95% RH w/no condensation Operating temperature:
UPS: 0°C to +40°C. (-32°F to 102°F)
Battery: 20°C to +30°C. (68°F to 86°F)
Storage temperature: -20 to 60C.
Safety Agencies: CSA Listed to UL924, UL924A, & UL1778